user manual
Table Of Contents
- Contents
- List of Figures
- List of Tables
- Preface
- Section I
- Getting Started
- Chapter 1
- Chapter 2
- System Configuration
- System Management Information
- Configuration of IP Address, Subnet Mask and Gateway Address
- IP Access List Configuration
- User Name and Password Configuration
- User Interface Configuration
- System Time
- SSL Settings
- DHCP and ATI Web Discovery Tool
- DHCP Client Configuration
- DHCP Auto Configuration
- System Information Display
- System Log Configuration
- System Configuration
- Section II
- Section III
- Advanced Features
- Chapter 16
- Chapter 17
- Chapter 18
- Chapter 19
- Chapter 20
- Chapter 21
- Chapter 22
- Chapter 23
- Chapter 24
- Chapter 25
- Section IV
- Appendix A
- Appendix B
Chapter 26: Software/Configuration Updates
328
Figure 127. Firmware Upgrade via TFTP Page
The Image/Version Date shows the current version and date of
software installed on the switch.
3. Change the following parameters as necessary:
TFTP Server IP: The IP address of the TFTP server from which
you are downloading the new software.
Image File Name: The full name of the AT-S111 file (including the
file extension) you are downloading.
Retry Count: The number of times the firmware upgrade is retried.
The range is 1 - 20.
4. To activate your changes on the switch, click Apply.
The software immediately begins to download onto the switch. This
process takes a few minutes. After the software download is complete,
the switch initializes the software and reboots. You will lose your web
browser connection to the switch during the reboot process.