user manual
Table Of Contents
- Contents
- List of Figures
- List of Tables
- Preface
- Section I
- Getting Started
- Chapter 1
- Chapter 2
- System Configuration
- System Management Information
- Configuration of IP Address, Subnet Mask and Gateway Address
- IP Access List Configuration
- User Name and Password Configuration
- User Interface Configuration
- System Time
- SSL Settings
- DHCP and ATI Web Discovery Tool
- DHCP Client Configuration
- DHCP Auto Configuration
- System Information Display
- System Log Configuration
- System Configuration
- Section II
- Section III
- Advanced Features
- Chapter 16
- Chapter 17
- Chapter 18
- Chapter 19
- Chapter 20
- Chapter 21
- Chapter 22
- Chapter 23
- Chapter 24
- Chapter 25
- Section IV
- Appendix A
- Appendix B
Chapter 26: Software/Configuration Updates
326
2. From the Firmware Upgrade folder, select via HTTP.
The Firmware Upgrade via HTTP Page is displayed. See Figure 126.
Figure 126. Firmware Upgrade via HTTP Page
3. Change the following parameter as necessary:
Firmware File: Enter the path and the firmware file name or click
the Browse button and select the file name.
4. To begin the upgrade process on the switch, click Apply.
The software begins to download onto the switch immediately. This
process takes a few minutes. After the software download is complete,
the switch initializes the software and reboots. You will lose your web
browser connection to the switch during the reboot process.