user manual
Table Of Contents
- Contents
- List of Figures
- List of Tables
- Preface
- Section I
- Getting Started
- Chapter 1
- Chapter 2
- System Configuration
- System Management Information
- Configuration of IP Address, Subnet Mask and Gateway Address
- IP Access List Configuration
- User Name and Password Configuration
- User Interface Configuration
- System Time
- SSL Settings
- DHCP and ATI Web Discovery Tool
- DHCP Client Configuration
- DHCP Auto Configuration
- System Information Display
- System Log Configuration
- System Configuration
- Section II
- Section III
- Advanced Features
- Chapter 16
- Chapter 17
- Chapter 18
- Chapter 19
- Chapter 20
- Chapter 21
- Chapter 22
- Chapter 23
- Chapter 24
- Chapter 25
- Section IV
- Appendix A
- Appendix B
AT-GS950/48PS Switch Web Interface User’s Guide
305
Global Configuration
The LLDP Global Setting page has three sections:
On the top of the page contains the enabling or disabling LLDP
selections.
The middle of the page contains LLDP System Information.
The LLDP port settings are on the bottom of the page.
3. See Figure 121 for an example of a partial view of this page.
A partial view of the AT-GS950/48PS LLDP Global Settings Page is
displayed. See Figure 121.
Figure 121. AT-GS950/48PS LLDP Global Settings Page
Perform the following procedures to configure the global parameters for
LLDP:
“Enabling or Disabling LLDP” on page 306
“Displaying System Information” on page 307