user manual
Table Of Contents
- Contents
- List of Figures
- List of Tables
- Preface
- Section I
- Getting Started
- Chapter 1
- Chapter 2
- System Configuration
- System Management Information
- Configuration of IP Address, Subnet Mask and Gateway Address
- IP Access List Configuration
- User Name and Password Configuration
- User Interface Configuration
- System Time
- SSL Settings
- DHCP and ATI Web Discovery Tool
- DHCP Client Configuration
- DHCP Auto Configuration
- System Information Display
- System Log Configuration
- System Configuration
- Section II
- Section III
- Advanced Features
- Chapter 16
- Chapter 17
- Chapter 18
- Chapter 19
- Chapter 20
- Chapter 21
- Chapter 22
- Chapter 23
- Chapter 24
- Chapter 25
- Section IV
- Appendix A
- Appendix B
AT-GS950/48PS Switch Web Interface User’s Guide
297
Trusted and Untrusted Port Configuration
The following procedure describes how to configure the DHCP Snooping
trusted interfaces on the AT-GS950/48PS switch:
1. From the main menu on the left side of the page, select DHCP
Snooping.
The DHCP Snooping folder expands.
2. From the DHCP Snooping folder, select Trusted Interfaces.
A partial view of the AT-GS950/48PS Trusted Interfaces page is
displayed. See Figure 117.
Figure 117. AT-GS950/48PS Trusted Interfaces Page
3. From the Trust column, select one of the following choices from the
pull-down menu:
Disable: This parameter defines the port as untrusted for the
DHCP Snooping feature.
Enable: This parameter defines the port as trusted for the DHCP
Snooping feature.
4. Click Apply for the port.
The port is now configured for you selection.
See Figure 118 on page 298 for a partial view of this page.