user manual
Table Of Contents
- Contents
- List of Figures
- List of Tables
- Preface
- Section I
- Getting Started
- Chapter 1
- Chapter 2
- System Configuration
- System Management Information
- Configuration of IP Address, Subnet Mask and Gateway Address
- IP Access List Configuration
- User Name and Password Configuration
- User Interface Configuration
- System Time
- SSL Settings
- DHCP and ATI Web Discovery Tool
- DHCP Client Configuration
- DHCP Auto Configuration
- System Information Display
- System Log Configuration
- System Configuration
- Section II
- Section III
- Advanced Features
- Chapter 16
- Chapter 17
- Chapter 18
- Chapter 19
- Chapter 20
- Chapter 21
- Chapter 22
- Chapter 23
- Chapter 24
- Chapter 25
- Section IV
- Appendix A
- Appendix B
AT-GS950/48PS Switch Web Interface User’s Guide
295
VLAN Setting
You can create and delete DHCP Snooping VLAN settings by following the
procedures in these sections:
"Creating a VLAN"
“Modifying a VLAN” on page 296
“Deleting a VLAN” on page 296
Creating a VLAN To define a VLAN that will be a part of the DHCP Snooping feature, do the
following:
1. From the main menu on the left side of the page, select DHCP
Snooping.
The DHCP Snooping folder expands.
2. From the DHCP Snooping folder, select VLAN Settings.
The VLAN Settings page is displayed. See Figure 116.
Figure 116. DHCP Snooping VLAN Settings Page.
3. In the VLAN ID field, enter a VLAN ID that has been pre-defined.
See “Tagged VLAN Configuration” on page 157 for information about
configuring VLANs.
4. Click Add.
The new VLAN ID entry is displayed in the table on the page.
5. If you find more than one VLAN ID to configure for DHCP Snooping,
enter them one at a time by following steps 3 and 4.
6. From the main menu on the left side of the page, select Save
Configuration to Flash to permanently save your changes.