user manual
Table Of Contents
- Contents
- List of Figures
- List of Tables
- Preface
- Section I
- Getting Started
- Chapter 1
- Chapter 2
- System Configuration
- System Management Information
- Configuration of IP Address, Subnet Mask and Gateway Address
- IP Access List Configuration
- User Name and Password Configuration
- User Interface Configuration
- System Time
- SSL Settings
- DHCP and ATI Web Discovery Tool
- DHCP Client Configuration
- DHCP Auto Configuration
- System Information Display
- System Log Configuration
- System Configuration
- Section II
- Section III
- Advanced Features
- Chapter 16
- Chapter 17
- Chapter 18
- Chapter 19
- Chapter 20
- Chapter 21
- Chapter 22
- Chapter 23
- Chapter 24
- Chapter 25
- Section IV
- Appendix A
- Appendix B
AT-GS950/48PS Switch Web Interface User’s Guide
277
Figure 110. Dial-In User Page
3. In the User Name field, type a name for the user.
4. In the Password field, type a password for the user.
5. In the Dynamic VLAN field, enter the VID of the VLAN which you will
allow the user to access. If you enter 0, this field will be ignored.
6. Click the Add button.
The Dial-in User page is refreshed. See Figure 111.
Figure 111. Dial-In User Page Example
7. To permanently save these settings in the configuration file, select
Save Configuration to Flash from the main menu to permanently
save your changes.
Modify a Dial-in User
To modify the settings for a dial-in user, do the following:
1. From the main menu on the left side of the page, select the Security
folder.
The Security folder expands.
2. From the Security folder, Dial-in User.