user manual
Table Of Contents
- Contents
- List of Figures
- List of Tables
- Preface
- Section I
- Getting Started
- Chapter 1
- Chapter 2
- System Configuration
- System Management Information
- Configuration of IP Address, Subnet Mask and Gateway Address
- IP Access List Configuration
- User Name and Password Configuration
- User Interface Configuration
- System Time
- SSL Settings
- DHCP and ATI Web Discovery Tool
- DHCP Client Configuration
- DHCP Auto Configuration
- System Information Display
- System Log Configuration
- System Configuration
- Section II
- Section III
- Advanced Features
- Chapter 16
- Chapter 17
- Chapter 18
- Chapter 19
- Chapter 20
- Chapter 21
- Chapter 22
- Chapter 23
- Chapter 24
- Chapter 25
- Section IV
- Appendix A
- Appendix B
Chapter 21: Security
270
5. To set the advanced configuration parameters, click Settings.
The Port Access Control Configure page is expanded. See Figure 108.
Figure 108. Expanded Port Access Control Configuration Page
6. Set the following parameters as needed:
Port: This parameter specifies the port being configured for
authentication.
Authentication Mode: This parameter specifies the port-based
authentication mode. The pull-down menu choices are as follows:
802.1x: 802.1x is specified as the authentication mode. This
setting applies to configuration for either RADIUS or Dial-In User
authentication. For configuration information, see either
“RADIUS Client” on page 273or “Dial-in User— Local
Authentication” on page 276.
MAC Based: MAC Based authentication mode is specified. For
more information about configuring this mode, see “Destination
MAC Filter” on page 279.
Port Control: This parameter specifies the port-based
authentication role. The pull-down menu choices are as follows:
Forced Unauthorized: This parameter sets the port to the