user manual
Table Of Contents
- Contents
- List of Figures
- List of Tables
- Preface
- Section I
- Getting Started
- Chapter 1
- Chapter 2
- System Configuration
- System Management Information
- Configuration of IP Address, Subnet Mask and Gateway Address
- IP Access List Configuration
- User Name and Password Configuration
- User Interface Configuration
- System Time
- SSL Settings
- DHCP and ATI Web Discovery Tool
- DHCP Client Configuration
- DHCP Auto Configuration
- System Information Display
- System Log Configuration
- System Configuration
- Section II
- Section III
- Advanced Features
- Chapter 16
- Chapter 17
- Chapter 18
- Chapter 19
- Chapter 20
- Chapter 21
- Chapter 22
- Chapter 23
- Chapter 24
- Chapter 25
- Section IV
- Appendix A
- Appendix B
AT-GS950/48PS Switch Web Interface User’s Guide
265
OUI Setting
You can create and delete Voice VLAN OUI Settings by following the
procedures in these sections:
“Create OUI Setting”
“Modify OUI Setting” on page 266
Create OUI
Setting
To create a Voice OUI configuration, perform the following procedure:
1. From the main menu on the left side of the page, select Bridge.
The Bridge folder expands.
2. From the Bridge folder, select Voice VLAN.
The Voice VLAN folder expands.
3. From the Voice VLAN folder, select Voice VLAN OUI Setting.
The Voice VLAN OUI Setting Page is displayed. See Figure 106.
Figure 106. Voice VLAN OUI Setting Page.
4. Enter a text description that helps you identify the manufacturer’s OUI
in the User Defined OUI - Description field. This parameter can be up
to 20 characters in length.
5. Enter the MAC address in the User Defined OUI - Telephony OUI
field of one of the IP phones with the manufacturer's OUI described in
step 4.
6. Click Add. The new OUI entry is displayed in the table at the bottom of
the page.
7. If you find more than one OUI among the IP phones you are installing,
enter one MAC address that represents each individual OUI by
following steps 4 through 6. You can enter a total of 10 OUIs.