user manual
Table Of Contents
- Contents
- List of Figures
- List of Tables
- Preface
- Section I
- Getting Started
- Chapter 1
- Chapter 2
- System Configuration
- System Management Information
- Configuration of IP Address, Subnet Mask and Gateway Address
- IP Access List Configuration
- User Name and Password Configuration
- User Interface Configuration
- System Time
- SSL Settings
- DHCP and ATI Web Discovery Tool
- DHCP Client Configuration
- DHCP Auto Configuration
- System Information Display
- System Log Configuration
- System Configuration
- Section II
- Section III
- Advanced Features
- Chapter 16
- Chapter 17
- Chapter 18
- Chapter 19
- Chapter 20
- Chapter 21
- Chapter 22
- Chapter 23
- Chapter 24
- Chapter 25
- Section IV
- Appendix A
- Appendix B
AT-GS950/48PS Switch Web Interface User’s Guide
251
snapshot of RMON statistics. Different ports can have different
numbers of buckets. The range is 1 to 50 buckets.
Interval: This parameter specifies how frequently the switch takes
snapshots of the port’s statistics. The range is 1 to 3600 seconds
(1 hour). For example, if you want the switch to take one snapshot
every minute on a port, you specify an interval of sixty seconds.
Owner: This parameter is used to identify the person who created
an entry. It is primarily intended for switches that are managed by
more than one person, and is an optional field.
4. Once you have configured the parameters, click Add.
Your entry appears in the table at the bottom of the page. See Figure
100.
Figure 100. History Control Configuration Example Page
5. If you want to configure additional RMON histories for other ports,
repeat steps 3 and 4.
6. From the main menu on the left side of the page, select Save
Configuration to Flash to permanently save your changes.