user manual
Table Of Contents
- Contents
- List of Figures
- List of Tables
- Preface
- Section I
- Getting Started
- Chapter 1
- Chapter 2
- System Configuration
- System Management Information
- Configuration of IP Address, Subnet Mask and Gateway Address
- IP Access List Configuration
- User Name and Password Configuration
- User Interface Configuration
- System Time
- SSL Settings
- DHCP and ATI Web Discovery Tool
- DHCP Client Configuration
- DHCP Auto Configuration
- System Information Display
- System Log Configuration
- System Configuration
- Section II
- Section III
- Advanced Features
- Chapter 16
- Chapter 17
- Chapter 18
- Chapter 19
- Chapter 20
- Chapter 21
- Chapter 22
- Chapter 23
- Chapter 24
- Chapter 25
- Section IV
- Appendix A
- Appendix B
AT-GS950/48PS Switch Web Interface User’s Guide
243
Policy Sequence Status
The Policy Sequence page displays the status of the order that policies are
applied to each port. You can order the display by Policy Index or by Policy
Sequence number.
To display the policy sequence, perform the following procedure:
1. From the main menu on the left side of the page, select the Access
Control Config folder.
The Access Control Config folder expands.
2. From the Access Control Config folder, select Policy Sequence.
The Policy Sequence page is displayed in Figure 94.
Figure 94. Policy Sequence Page
3. Select the switch port from the Select Port pull down menu that you
want to view.
4. Click either the Display by Index order or Display by Sequence
order button to view the Policy Sequence.
The Policy Sequence page with the Display by Index pull down menu
selected is displayed in Figure 95.
Figure 95. Policy Sequence Page with Display by Index Selected