user manual
Table Of Contents
- Contents
- List of Figures
- List of Tables
- Preface
- Section I
- Getting Started
- Chapter 1
- Chapter 2
- System Configuration
- System Management Information
- Configuration of IP Address, Subnet Mask and Gateway Address
- IP Access List Configuration
- User Name and Password Configuration
- User Interface Configuration
- System Time
- SSL Settings
- DHCP and ATI Web Discovery Tool
- DHCP Client Configuration
- DHCP Auto Configuration
- System Information Display
- System Log Configuration
- System Configuration
- Section II
- Section III
- Advanced Features
- Chapter 16
- Chapter 17
- Chapter 18
- Chapter 19
- Chapter 20
- Chapter 21
- Chapter 22
- Chapter 23
- Chapter 24
- Chapter 25
- Section IV
- Appendix A
- Appendix B
AT-GS950/48PS Switch Web Interface User’s Guide
227
In-Profile Action
The Create In-Profile Action page allows you to specify a Profile Action’s
Permit or Deny privilege for packets in the ingress queue.
Note
A Profile Action Index is required to create an In-Profile Action.
See “Creating a Profile Action” on page 224 for more information.
You can create, modify or delete an In-Profile Action by following the
procedures in the following sections:
“Creating an In-Profile Action,” next
“Modifying an In-Profile Action” on page 229
“Deleting an In-Profile Action” on page 230
Creating an In-
Profile Action
To create an in-profile action, perform the following procedure:
1. From the main menu on the left side of the page, select the Access
Control Config folder.
The Access Control Config folder expands.
2. From the Access Control Config folder, select In-Profile Action.
The Create In-Profile Action page is displayed in Figure 82.
Figure 82. Create In-Profile Action Page Example
3. Enter a number in the In-Profile Action Index field. The Index must be
a unique number within the range of 1 - 65535. This field is mandatory.