user manual
Table Of Contents
- Contents
- List of Figures
- List of Tables
- Preface
- Section I
- Getting Started
- Chapter 1
- Chapter 2
- System Configuration
- System Management Information
- Configuration of IP Address, Subnet Mask and Gateway Address
- IP Access List Configuration
- User Name and Password Configuration
- User Interface Configuration
- System Time
- SSL Settings
- DHCP and ATI Web Discovery Tool
- DHCP Client Configuration
- DHCP Auto Configuration
- System Information Display
- System Log Configuration
- System Configuration
- Section II
- Section III
- Advanced Features
- Chapter 16
- Chapter 17
- Chapter 18
- Chapter 19
- Chapter 20
- Chapter 21
- Chapter 22
- Chapter 23
- Chapter 24
- Chapter 25
- Section IV
- Appendix A
- Appendix B
Chapter 18: Access Control Configuration
224
Profile Action
The Create Profile Action page defines the priority parameters for policing
on DSCP (layer 3) and/or class of service (layer 2).
Note
You must enter a Profile Index on this page even if you do not define
the Policed-DHCP and Policed-CoS parameters because the
Profile Index is a required parameter for creating both the In-Profile
and Out-Profile Actions. Refer to “Creating an In-Profile Action” on
page 227 and “Creating a Out-Profile Action” on page 231 for more
information.
You can create, modify or delete a Profile Action by following the
procedures in the following sections:
“Creating a Profile Action,” next
“Modifying Profile Action” on page 225
“Deleting a Profile Action” on page 226
Creating a Profile
Action
To create a profile action, perform the following procedure:
1. From the main menu on the left side of the page, select the Access
Control Config folder.
The Access Control Config folder expands.
2. From the Access Control Config folder, select Profile Action.
The Create Profile Action page is displayed in Figure 79.
Figure 79. Create Profile Action Page