user manual
Table Of Contents
- Contents
- List of Figures
- List of Tables
- Preface
- Section I
- Getting Started
- Chapter 1
- Chapter 2
- System Configuration
- System Management Information
- Configuration of IP Address, Subnet Mask and Gateway Address
- IP Access List Configuration
- User Name and Password Configuration
- User Interface Configuration
- System Time
- SSL Settings
- DHCP and ATI Web Discovery Tool
- DHCP Client Configuration
- DHCP Auto Configuration
- System Information Display
- System Log Configuration
- System Configuration
- Section II
- Section III
- Advanced Features
- Chapter 16
- Chapter 17
- Chapter 18
- Chapter 19
- Chapter 20
- Chapter 21
- Chapter 22
- Chapter 23
- Chapter 24
- Chapter 25
- Section IV
- Appendix A
- Appendix B
AT-GS950/48PS Switch Web Interface User’s Guide
221
5. Click ADD.
The classifier entry is displayed in the table at the bottom of the page.
If you do not see you new entry, you may need to navigate to another
page of the table with the First Page, Previous Page, Next Page, and
Last Page buttons located below the table. An example of a classifier
table entry is shown in Figure 77.
Figure 77. Create Classifier Example Page
6. From the main menu on the left side of the page, select Save
Configuration to Flash to permanently save your changes.
Modifying a
Classifier
To modify the entries for a Classifier, perform the following procedure:
Note
You must enter a classifier before you can modify it. See “Creating a
Classifier” on page 219 for more information.
1. From the main menu on the left side of the page, select the Access
Control Config folder.
The Access Control Config folder expands.