user manual
Table Of Contents
- Contents
- List of Figures
- List of Tables
- Preface
- Section I
- Getting Started
- Chapter 1
- Chapter 2
- System Configuration
- System Management Information
- Configuration of IP Address, Subnet Mask and Gateway Address
- IP Access List Configuration
- User Name and Password Configuration
- User Interface Configuration
- System Time
- SSL Settings
- DHCP and ATI Web Discovery Tool
- DHCP Client Configuration
- DHCP Auto Configuration
- System Information Display
- System Log Configuration
- System Configuration
- Section II
- Section III
- Advanced Features
- Chapter 16
- Chapter 17
- Chapter 18
- Chapter 19
- Chapter 20
- Chapter 21
- Chapter 22
- Chapter 23
- Chapter 24
- Chapter 25
- Section IV
- Appendix A
- Appendix B
AT-GS950/48PS Switch Web Interface User’s Guide
211
Modifying
SNMPv3 View
Names
If you need to modify an entry in the SNMP Group Access page, you must
first delete the entry and then re-enter it. For information about how to
delete an entry in this table, see “Deleting SNMPv3 View Names” on
page 211. For information about how to create a new entry in this table,
see “Creating SNMPv3 View Names” on page 209.
Deleting SNMPv3
View Names
This procedure explains how to delete an entry on the SNMP Group
Access Table page.
1. From the main menu on the left side of the page, select the SNMP
folder.
The SNMP folder expands.
2. From the SNMP folder, select SNMP Access Table.
The SNMP Group Access Table page is displayed. See Figure 72 on
page 209.
3. In the Action column of the table, click Delete for the View Name that
you want to remove.
Note
The views corresponding to the ReadOnly and ReadWrite Group
Names are default values and cannot be removed.
4. From the main menu on the left side of the page, select Save
Configuration to Flash to permanently save your changes.