user manual

AT-GS950/48PS Switch Web Interface User’s Guide
209
SNMPv3 View Names
The SNMPv3 View names are defined in the SNMP Group Access table
and are based on the User and Group Names.You can create and delete
View Names with the following procedures:
 “Creating SNMPv3 View Names” on page 209
 “Modifying SNMPv3 View Names” on page 211
 “Deleting SNMPv3 View Names” on page 211
Creating
SNMPv3 View
Names
Before you can create an SNMPv3 View name, you must defined a Group
Name using the SNMP User/Group page. See “Creating SNMPv3 User
and Group Names” on page 206.
Use this procedure to create SNMPv3 View Names.
1. From the main menu on the left side of the page, select the SNMP
folder.
The SNMP folder expands.
2. From the SNMP folder, select Group Access Table.
The SNMP Group Access Table page is displayed. See Figure 72.
Figure 72. SNMP Group Access Table
3. Enter the Group Name.
Note
This entry must be pre-defined on the SNMP User/Group page. See
“Creating SNMPv3 View Names” on page 209.
4. Enter the Read View Name.