user manual
Table Of Contents
- Contents
- List of Figures
- List of Tables
- Preface
- Section I
- Getting Started
- Chapter 1
- Chapter 2
- System Configuration
- System Management Information
- Configuration of IP Address, Subnet Mask and Gateway Address
- IP Access List Configuration
- User Name and Password Configuration
- User Interface Configuration
- System Time
- SSL Settings
- DHCP and ATI Web Discovery Tool
- DHCP Client Configuration
- DHCP Auto Configuration
- System Information Display
- System Log Configuration
- System Configuration
- Section II
- Section III
- Advanced Features
- Chapter 16
- Chapter 17
- Chapter 18
- Chapter 19
- Chapter 20
- Chapter 21
- Chapter 22
- Chapter 23
- Chapter 24
- Chapter 25
- Section IV
- Appendix A
- Appendix B
AT-GS950/48PS Switch Web Interface User’s Guide
207
8. Enter the password for the Auth-Protocol.
9. Select one of the following choices for the Priv-Protocol field:
DES: Specifies DES encryption scrambles the SNMP data so that
outside observers are prevented from seeing the data content.
none: Specifies no encryption is applied to SNMP data.
Note
If you specify a privacy password, the privacy protocol is set to DES
and you must also specify an authentication protocol and password.
10. Click Add.
The new User Name and Group Name are displayed on the SNMP
User/Group page. See Figure 71.
Figure 71. SNMP User Group, SNMPv3 Example
11. From the main menu on the left side of the page, select Save
Configuration to Flash to permanently save your changes.
Modifying
SNMPv3 User
and Group
Names
If you need to modify an entry in the SNMP User/Group page, you must
first delete the entry and then re-enter it. For information about how to
delete an entry in this table, see “Deleting SNMPv3 User and Group
Names” on page 208. For information about how to create a new entry in
this table, see “Creating SNMPv3 User and Group Names” on page 206