user manual
Table Of Contents
- Contents
- List of Figures
- List of Tables
- Preface
- Section I
- Getting Started
- Chapter 1
- Chapter 2
- System Configuration
- System Management Information
- Configuration of IP Address, Subnet Mask and Gateway Address
- IP Access List Configuration
- User Name and Password Configuration
- User Interface Configuration
- System Time
- SSL Settings
- DHCP and ATI Web Discovery Tool
- DHCP Client Configuration
- DHCP Auto Configuration
- System Information Display
- System Log Configuration
- System Configuration
- Section II
- Section III
- Advanced Features
- Chapter 16
- Chapter 17
- Chapter 18
- Chapter 19
- Chapter 20
- Chapter 21
- Chapter 22
- Chapter 23
- Chapter 24
- Chapter 25
- Section IV
- Appendix A
- Appendix B
AT-GS950/48PS Switch Web Interface User’s Guide
173
GarpLeaveAllTime - This parameter is the GARP Leave Timer.Its
range si 30 - 2147483630 milli-seconds. This timer must be set in
relation to the GVRP Leave Timer according to the following
equation:
GARPLeaveAllTimer > (GARPLeaveTimer + 10)
Note
To ensure compatibility between network devices, you need
to configure the same values for the GARP Join Timer, GARP Leave
Timer, and GARP Leave All Timer on all participating GVRP devices
in your network.
5. Once you have configured the parameters, click Apply for the affected
port.
6. If you want to configure the GVRP timers for other ports, repeat
steps 4 and 5.
7. From the main menu on the left side of the page, select Save
Configuration to Flash to permanently save your changes.