user manual
Table Of Contents
- Contents
- List of Figures
- List of Tables
- Preface
- Section I
- Getting Started
- Chapter 1
- Chapter 2
- System Configuration
- System Management Information
- Configuration of IP Address, Subnet Mask and Gateway Address
- IP Access List Configuration
- User Name and Password Configuration
- User Interface Configuration
- System Time
- SSL Settings
- DHCP and ATI Web Discovery Tool
- DHCP Client Configuration
- DHCP Auto Configuration
- System Information Display
- System Log Configuration
- System Configuration
- Section II
- Section III
- Advanced Features
- Chapter 16
- Chapter 17
- Chapter 18
- Chapter 19
- Chapter 20
- Chapter 21
- Chapter 22
- Chapter 23
- Chapter 24
- Chapter 25
- Section IV
- Appendix A
- Appendix B
AT-GS950/48PS Switch Web Interface User’s Guide
169
General Configuration
Perform the following procedure to enable or disable GVRP:
1. From the main menu on the left side of the page, select Bridge.
The Bridge folder expands.
2. From the Bridge folder, select GVRP.
The GVRP folder expands.
3. From the GVRP folder, select GVRP Global Configuration.
The GVRP Global Configuration Page is displayed. See Figure 56.
Figure 56. GVRP Global Configuration Page
4. From the GVRP Status field, select one of the following choices from
the pull-down menu:
Enable - The GVRP feature is active.
Disable - The GVRP feature is inactive.
5. Click Apply.
The GVRP setting that you have selected is now active.
6. From the main menu on the left side of the page, select Save
Configuration to Flash to permanently save your changes.