user manual
Table Of Contents
- Contents
- List of Figures
- List of Tables
- Preface
- Section I
- Getting Started
- Chapter 1
- Chapter 2
- System Configuration
- System Management Information
- Configuration of IP Address, Subnet Mask and Gateway Address
- IP Access List Configuration
- User Name and Password Configuration
- User Interface Configuration
- System Time
- SSL Settings
- DHCP and ATI Web Discovery Tool
- DHCP Client Configuration
- DHCP Auto Configuration
- System Information Display
- System Log Configuration
- System Configuration
- Section II
- Section III
- Advanced Features
- Chapter 16
- Chapter 17
- Chapter 18
- Chapter 19
- Chapter 20
- Chapter 21
- Chapter 22
- Chapter 23
- Chapter 24
- Chapter 25
- Section IV
- Appendix A
- Appendix B
AT-GS950/48PS Switch Web Interface User’s Guide
131
Note
An error message is generated when you enter a VLAN ID or VLAN
Index which is not been defined or when you enter a
VLAN ID or VLAN Index without also clicking on the respective
radio button.
4. In the Group MAC Address field, enter a multicast MAC address.
The range is from 01:00:5E:00:01:00 to 01:00:5E:7F:FF:FF.
5. Assign the MAC address a Group Member (or members) by selecting
the check box beside each port number.
Note
You can assign a maximum limit of 256 static multicast addresses
on the switch.
6. Click Add.
The Static Multicast Address Table is updated with the new MAC
Address.
See Figure 42 for a partial view of this page.
Hello
Figure 42. Static Multicast Address Table Example
Note
The Group MAC Address values that you enter on the Static
Multicast Address Table Page are also displayed on the IGMP
Snooping Page. For more information, see “IGMP Snooping
Configuration” on page 138.