user manual
Table Of Contents
- Contents
- List of Figures
- List of Tables
- Preface
- Section I
- Getting Started
- Chapter 1
- Chapter 2
- System Configuration
- System Management Information
- Configuration of IP Address, Subnet Mask and Gateway Address
- IP Access List Configuration
- User Name and Password Configuration
- User Interface Configuration
- System Time
- SSL Settings
- DHCP and ATI Web Discovery Tool
- DHCP Client Configuration
- DHCP Auto Configuration
- System Information Display
- System Log Configuration
- System Configuration
- Section II
- Section III
- Advanced Features
- Chapter 16
- Chapter 17
- Chapter 18
- Chapter 19
- Chapter 20
- Chapter 21
- Chapter 22
- Chapter 23
- Chapter 24
- Chapter 25
- Section IV
- Appendix A
- Appendix B
Chapter 10: MAC Address Table
130
Static Multicast Address Configuration
This procedure explains how to set the static multicast feature for each
port on the AT-GS950/48PS switch. Before beginning this procedure, you
must create an 802.1Q VLAN ID or a Port-Based VLAN Index. For
information about defining these parameters, see:
“Tagged VLAN Configuration” on page 157 regarding the 802.1Q
VLAN ID parameter.
“Port-Based VLAN Configuration” on page 164 regarding the Port-
Based VLAN Index parameter.
To add a static MAC address to the switch, perform the following
procedure:
1. From the main menu on the left side of the page, select the Bridge
folder.
The Bridge folder expands.
2. From the Bridge folder, select Static Multicast.
The Static Multicast Address Table Page is displayed.
See Figure 41 for a partial view of this page.
Figure 41. AT-GS950/48PS Static Multicast Address Table Page
3. Select either the 802.1Q VLAN ID or Port-Based VLAN Index radio
button and enter the respective VLAN ID (1-4000) or VLAN Index (1 -
52).