user manual
Table Of Contents
- Contents
- List of Figures
- List of Tables
- Preface
- Section I
- Getting Started
- Chapter 1
- Chapter 2
- System Configuration
- System Management Information
- Configuration of IP Address, Subnet Mask and Gateway Address
- IP Access List Configuration
- User Name and Password Configuration
- User Interface Configuration
- System Time
- SSL Settings
- DHCP and ATI Web Discovery Tool
- DHCP Client Configuration
- DHCP Auto Configuration
- System Information Display
- System Log Configuration
- System Configuration
- Section II
- Section III
- Advanced Features
- Chapter 16
- Chapter 17
- Chapter 18
- Chapter 19
- Chapter 20
- Chapter 21
- Chapter 22
- Chapter 23
- Chapter 24
- Chapter 25
- Section IV
- Appendix A
- Appendix B
AT-GS950/48PS Switch Web Interface User’s Guide
127
Note
An error message is generated when you enter a VLAN ID or VLAN
Index which is not been defined or when you enter a
VLAN ID or VLAN Index without also clicking on the respective
radio button.
4. In the Group MAC Address field, enter a unicast MAC address.
5. Assign the MAC address a Port Member (or members) by selecting
the check box beside each port number.
Note
You can assign a maximum limit of 256 static unicast addresses on
the switch.
6. Click Add.
The Static Unicast Address Table is updated and displayed with the
new MAC Address.
See Figure 39 for a partial view of an example of a Port-based VLAN.
Figure 39. Static Unicast Address Table with Port-Base VLAN Example
7. From the main menu on the left side of the page, select Save
Configuration to Flash to permanently save your changes.