user manual
Table Of Contents
- Contents
- List of Figures
- List of Tables
- Preface
- Section I
- Getting Started
- Chapter 1
- Chapter 2
- System Configuration
- System Management Information
- Configuration of IP Address, Subnet Mask and Gateway Address
- IP Access List Configuration
- User Name and Password Configuration
- User Interface Configuration
- System Time
- SSL Settings
- DHCP and ATI Web Discovery Tool
- DHCP Client Configuration
- DHCP Auto Configuration
- System Information Display
- System Log Configuration
- System Configuration
- Section II
- Section III
- Advanced Features
- Chapter 16
- Chapter 17
- Chapter 18
- Chapter 19
- Chapter 20
- Chapter 21
- Chapter 22
- Chapter 23
- Chapter 24
- Chapter 25
- Section IV
- Appendix A
- Appendix B
Chapter 6: Static Port Trunking
100
A check in a box indicates the port is a member of the trunk. No check
means the port is not a member. A port trunk can contain up to eight
ports.
5. Change the Trunk Status from Disable to another setting. The choice
in the status field are the following:
Active - The specific aggregator will broadcast and respond to
LACPDU (LACP Data Unit) packets. This setting enables
the LACP feature for the trunk.
Passive - The specific aggregator will not broadcast LACPDU
packets, but it will respond to them. This setting disables the LACP
feature for the trunk.
Manual - Enables static port trunking and disables the LACP
feature for the trunk.
Disable - Disables the static port trunk and disables the LACP
feature for the trunk.
6. Click Apply.
7. If you did not select the trunk mode Disabled, the trunk is now
operational on the switch.
8. From the main menu on the left side of the page, select Save
Configuration to Flash to permanently save your changes.
9. Configure the port trunk on the other switch.
10. Connect the Ethernet cables between trunk ports on the AT-GS950/
48PS switch and the trunk ports on the other switch.