User's Manual
Table Of Contents
- Contents
- Figures
- Preface
- Chapter 1
- AlliedWare Plus™ Version 2.1.2 Web Browser Interface
- Chapter 2
- Starting a Management Session
- Chapter 3
- Basic Switch Parameters
- Setting the System Date and Time
- Setting a Telnet or SSH Server
- Setting a Remote Log Server
- Setting the Switch Information
- Setting the Configuration File
- Managing User Accounts
- Rebooting a Switch
- Upgrading the Software
- Returning the AlliedWare Plus Management Software to the Factory Default Values
- Displaying System Information
- Chapter 4
- Setting Port Parameters
- Chapter 5
- Setting Port Statistics
- Chapter 6
- Setting Port Mirroring
- Chapter 7
- Setting the Port Spanning Tree Protocol
- Chapter 8
- Setting the MAC Address
- Chapter 9
- Setting LACP
- Chapter 10
- Setting Static Port Trunks
- Chapter 11
- Setting Port-based and Tagged VLANs
- Chapter 12
- Setting Switch Spanning Tree Protocols
- Chapter 13
- Setting Internet Group Management Protocol (IGMP) Snooping
- Chapter 14
- Setting MAC Address-based Port Security
- Chapter 15
- Setting RADIUS and TACACS+ Clients
- Chapter 16
- Setting 802.1x Port-based Network Access
- Chapter 17
- Setting IPv4 and IPv6 Management
- Chapter 18
- Setting LLDP and LLDP-MED
- Chapter 19
- Setting sFlow
AlliedWare Plus Version 2.1.2 Management Software Web Browser User’s Guide
55
System Contact— Indicates the contact person for the switch. To
configure this field, see “Setting the Switch Information” on
page 41.
System Location— Indicates the location of the switch. To
configure this field, see “Setting the Switch Information” on
page 41.
Management VLAN— Displays the management VLAN assigned
to the switch. The default VLAN is “VLAN1.”
IPv6 Gateway— Displays the IPv6 address of the next hop of the
switch’s default route. The switch uses a default route when it
receives a network packet for routing, but it cannot find an
available route in the routing table.
IPv6 Address— Displays the IPv6 address and subnet mask of
the web interface. An IPv6 management address for the switch is
entered in the following format:
nnnn:nnnn:nnnn:nnnn:nnnn:nnnn:nnnn:nnnn
Where “n” is a hexadecimal digit from 0 to F. The eight groups of
digits are separated by colons. Groups where all four digits are ‘0’
can be omitted. Leading ‘0’s in groups can also be omitted. For
example, the following IPv6 addresses are equivalent:
12c4:421e:09a8:0000:0000:0000:00a4:1c50
12c4:421e:9a8::a4:1c50
The Services section displays the following information:
SNMP— Indicates the SNMP setting of the switch.
HTTP— Indicates the HTTP setting of the switch
Telnet— Indicates if Telnet is enabled or disabled on the switch.
SSH— Indicates if SSH is enabled or disabled on the switch.
Spanning Tree— Indicates if RSTP or STP is enabled on the
switch. The default setting is RSTP.
QoS— Indicates is QoS is enabled or disabled on the switch.
LLDP— Indicates if LLDP is enabled or disabled on the switch.
SFLOW— Indicates is sFlow is enabled or disabled on the switch.
802.1x Port Authentication— Indicates if 802.1x Port
Authentication is enabled or disabled on the switch.
Remote Logging— Indicates if the remote log is enabled or
disabled on the switch.
IGMP Snooping— Indicates if IGMP Snooping is enabled or
disabled on the switch.