User's Manual
Table Of Contents
- Contents
- Figures
- Preface
- Chapter 1
- AlliedWare Plus™ Version 2.1.2 Web Browser Interface
- Chapter 2
- Starting a Management Session
- Chapter 3
- Basic Switch Parameters
- Setting the System Date and Time
- Setting a Telnet or SSH Server
- Setting a Remote Log Server
- Setting the Switch Information
- Setting the Configuration File
- Managing User Accounts
- Rebooting a Switch
- Upgrading the Software
- Returning the AlliedWare Plus Management Software to the Factory Default Values
- Displaying System Information
- Chapter 4
- Setting Port Parameters
- Chapter 5
- Setting Port Statistics
- Chapter 6
- Setting Port Mirroring
- Chapter 7
- Setting the Port Spanning Tree Protocol
- Chapter 8
- Setting the MAC Address
- Chapter 9
- Setting LACP
- Chapter 10
- Setting Static Port Trunks
- Chapter 11
- Setting Port-based and Tagged VLANs
- Chapter 12
- Setting Switch Spanning Tree Protocols
- Chapter 13
- Setting Internet Group Management Protocol (IGMP) Snooping
- Chapter 14
- Setting MAC Address-based Port Security
- Chapter 15
- Setting RADIUS and TACACS+ Clients
- Chapter 16
- Setting 802.1x Port-based Network Access
- Chapter 17
- Setting IPv4 and IPv6 Management
- Chapter 18
- Setting LLDP and LLDP-MED
- Chapter 19
- Setting sFlow
Chapter 3: Basic Switch Parameters
42
Change the following parameters as necessary:
System Name— Specifies a name for the switch (for example,
Sales Ethernet switch). The name is displayed only on the
Dashboard page. The name can be from 1 to 39 characters in
length. It can include spaces and special characters, such as
dashes and asterisks. By default, there is no system name. This
parameter is optional.
System Contact — Specifies the name of the network
administrator responsible for managing the switch. The name can
be from 1 to 20 characters. It can include spaces and special
characters, such as dashes and asterisks. The default is no name.
This parameter is optional.
System Location— Specifies the location of the switch, (for
example, 4th Floor - room 402B). The location can be from 1 to 20
characters. The location can include spaces and special
characters, such as dashes and asterisks. The default is no
location. This parameter is optional.
4. Click Apply.
5. Click S
AVE to activate your changes on the switch.