User's Manual

Chapter 18: Setting LLDP and LLDP-MED
232
Displaying LLDP and LLDP-MED Settings
To display the LLDP Civic, Coordinate, and ELIN locations, use the
following procedures:
 “Displaying the Basic LLDP Configuration” on page 232
 “Displaying LLDP Port Assignments” on page 233
 “Displaying Port Locations” on page 234
 “Displaying LLDP TLV” on page 234
 “Displaying LLDP-MED TLV” on page 236
For information about configuring LLDP and LLDP-MED, see “Configuring
LLDP and LLDP-MED” on page 210
Displaying the
Basic LLDP
Configuration
To display the basic LLDP configuration, do the following:
1. Select the Discovery & Monitoring tab.
The Discovery & Monitoring tab is displayed. See Figure 68 on page
201.
2. From the Discovery & Monitoring tab, select LLDP.
The LLDP tab appears to the right.
3. From the LLDP tab, select the Basic Configuration tab.
The LLDP Configuration page is displayed. See Figure 76 on page
211.
The following fields are displayed:
 Status— Indicates whether LLDP is enabled or disabled on the
switch. By default, LLDP is disabled on the switch.
 Timer— Specifies the transmit interval. The range is 5 to 32,768
seconds.
 Fast Start Count— Indicates the fast start count for LLDP-MED.
The fast start count determines how many fast start
advertisements LLDP sends from a port when it begins sending
LLDP-MED advertisements from a port, for instance when it
detects a new LLDP-MED capable device. The default value is 3.
 Holdtime Multiplier— Sets the holdtime multiplier value. The
transmit interval is multiplied by the holdtime multiplier to give the
Time To Live (TTL) the switch advertises to the neighbors. The
range is 2 to 10.
 Non Strict Med TLV Order Check— Sets the switch to accept
LLDP-MED advertisements even if the TLVs are not in the