User's Manual

Chapter 18: Setting LLDP and LLDP-MED
230
The following fields are displayed:
 Id— Specifies the LLDP Coordinate Location ID.
 Latitude— Indicates the latitude value in decimal degrees. The
range is -90.0º to 90.0º. The field accepts up to two digits to the
right of the decimal point.
 Latitude Resolution— Indicates the latitude resolution as the
number of valid bits. The range is 0 to 34 bits.
 Longitude— Specifies the longitude value in decimal degrees.
The range is -180.0º to 180.0º. The field accepts up to two digits to
the right of the decimal point.
 Longitude Resolution— Specifies the longitude resolution as the
number of valid bits. The range is 0 to 34 bits.
 Altitude— Specifies the altitude in meters or floors. For the
altitude in meters, the range is -2097151.0 to 2097151.0 meters.
The parameter accepts up to eight digits to the right of the decimal
point. For altitude in the number of floors, the range is -2097151.0
to 2097151.0. Use the Altitude Type field to specify meters or
floors.
 Altitude Resolution— Indicates the altitude resolution as the
number of valid bits. The range is 0 to 30 bits.
 Datum— The geodetic system (or datum) of the coordinates.
Choose one of the following:
nad83-mllw Mean lower low water datum 1983
nad83-navd North American vertical datum 1983
wgs84 World Geodetic System 1984
Displaying ELIN
Locations
To display an LLDP ELIN location, do the following:
1. Select the Discovery & Monitoring tab.
The Discovery & Monitoring tab is displayed. See Figure 68 on page
201.
2. From the Discovery & Monitoring tab, select LLDP.
The LLDP tab appears on the right.
3. From the LLDP tab, select Locations.
The Locations tab is displayed. See Figure 69 on page 202.
4. From the Location tab, select ELIN.
The LLDP ELIN Location page is displayed. See Figure 75 on page
208.