User's Manual
Table Of Contents
- Contents
- Figures
- Preface
- Chapter 1
- AlliedWare Plus™ Version 2.1.2 Web Browser Interface
- Chapter 2
- Starting a Management Session
- Chapter 3
- Basic Switch Parameters
- Setting the System Date and Time
- Setting a Telnet or SSH Server
- Setting a Remote Log Server
- Setting the Switch Information
- Setting the Configuration File
- Managing User Accounts
- Rebooting a Switch
- Upgrading the Software
- Returning the AlliedWare Plus Management Software to the Factory Default Values
- Displaying System Information
- Chapter 4
- Setting Port Parameters
- Chapter 5
- Setting Port Statistics
- Chapter 6
- Setting Port Mirroring
- Chapter 7
- Setting the Port Spanning Tree Protocol
- Chapter 8
- Setting the MAC Address
- Chapter 9
- Setting LACP
- Chapter 10
- Setting Static Port Trunks
- Chapter 11
- Setting Port-based and Tagged VLANs
- Chapter 12
- Setting Switch Spanning Tree Protocols
- Chapter 13
- Setting Internet Group Management Protocol (IGMP) Snooping
- Chapter 14
- Setting MAC Address-based Port Security
- Chapter 15
- Setting RADIUS and TACACS+ Clients
- Chapter 16
- Setting 802.1x Port-based Network Access
- Chapter 17
- Setting IPv4 and IPv6 Management
- Chapter 18
- Setting LLDP and LLDP-MED
- Chapter 19
- Setting sFlow
Chapter 15: Setting RADIUS and TACACS+ Clients
172
6. Change the following settings as needed:
IP Address— Specifies the IP address of a RADIUS server on the
network. The IP address must be in the following IPv4 format:
xxx.xxx.xxx.xxx.
Order— Select an index number for the IP address which
indicates the priority of the RADIUS server. The switch queries the
servers in the order in which they are listed in its table, starting with
1. The range is 1 to 3.
Accounting Port— Select the accounting port for the RADIUS
server. This is the UDP destination port for RADIUS accounting
requests. If you select 0, the server is not used for accounting. By
default, the UDP port for accounting is 1813.
Authentication Port— Specifies the UDP destination port for
RADIUS authentication requests. If you select 0, the server is not
used for authentication. The default UDP port for authentication is
1812.
Key— Specifies the encryption key used by this RADIUS server.
This value is needed when you configure a RADIUS client. The
maximum length is 39 characters. Spaces and special characters
are not permitted.
7. Click Save.