User's Manual
Table Of Contents
- Contents
- Figures
- Preface
- Chapter 1
- AlliedWare Plus™ Version 2.1.2 Web Browser Interface
- Chapter 2
- Starting a Management Session
- Chapter 3
- Basic Switch Parameters
- Setting the System Date and Time
- Setting a Telnet or SSH Server
- Setting a Remote Log Server
- Setting the Switch Information
- Setting the Configuration File
- Managing User Accounts
- Rebooting a Switch
- Upgrading the Software
- Returning the AlliedWare Plus Management Software to the Factory Default Values
- Displaying System Information
- Chapter 4
- Setting Port Parameters
- Chapter 5
- Setting Port Statistics
- Chapter 6
- Setting Port Mirroring
- Chapter 7
- Setting the Port Spanning Tree Protocol
- Chapter 8
- Setting the MAC Address
- Chapter 9
- Setting LACP
- Chapter 10
- Setting Static Port Trunks
- Chapter 11
- Setting Port-based and Tagged VLANs
- Chapter 12
- Setting Switch Spanning Tree Protocols
- Chapter 13
- Setting Internet Group Management Protocol (IGMP) Snooping
- Chapter 14
- Setting MAC Address-based Port Security
- Chapter 15
- Setting RADIUS and TACACS+ Clients
- Chapter 16
- Setting 802.1x Port-based Network Access
- Chapter 17
- Setting IPv4 and IPv6 Management
- Chapter 18
- Setting LLDP and LLDP-MED
- Chapter 19
- Setting sFlow
Chapter 15: Setting RADIUS and TACACS+ Clients
168
Configuring the Authentication Server
To configure an authentication server, choose from the following
procedures:
“Configuring a TACACS+ Server” on page 168
“Configuring a RADIUS Server” on page 170
Note
Before you can configure an TACACS+ or RADIUS server, you must
select an authentication method. See “Selecting the Authentication
Method” on page 166.
Configuring a
TACACS+
Server
To configure a TACACS+ server, do the following:
1. Select the Security tab.
The Security tab is displayed. See Figure 52 on page 158.
2. From the Security tab, select Authentication Servers.
The Authentication Server Configuration page is displayed. See Figure
55 on page 166.
3. Click the Tacacs+ tab.
The Authentication Server Configuration Page with the Tacacs+ tab is
displayed. See Figure 55 on page 166.
Note
You cannot change the Timeout Value for a TACACS+ server. This
field indicates the number of seconds, that the switch waits for a
response from a TACACS+ server to an authentication request,
before querying the next server in the list.
4. Specify the Key Value setting as needed.
This field defines the value of the global encryption key of the
TACACS+ servers. You can define a global encryption key if you have
one TACACS+ server or if there is more than one server and they all
use the same encryption key. This value is used by the TACACS+
clients. The maximum length is 39 characters. Spaces and special
characters are not permitted.The default value is “ATI.”