Install guide

Quick Install Guide 7
C613-04022-01 REV E
1. AT-A40 and AT-A41 Uplink Modules can be installed in Rapier G6 and G6F switches and all Rapier i
switches.
Where To Find More Information
Sources of further information.
Information on Uplink Modules:
■
The Uplink Module Hardware Reference, which provides detailed
information on Uplink Modules.
Information on Switches and Switching Routers:
■
The Hardware Reference for your switch or switching router, which provides
detailed information on the switch unit and its hardware features.
■
The Software Reference for your switch or switching router, which provides
detailed information on configuring the switch unit and its software.
■
The User Guide for your switch or switching router, which provides an
introduction to the switch unit’s Graphical User Interface and its Layer 2
switching features.
Information on other expansion options for the AR800 and Rapier Series:
■
The Network Service Module Quick Install Guide, which outlines the
procedure for installing an NSM; and the Network Service Module Hardware
Reference, which provides detailed information on NSMs.
■
The Port Interface Card Quick Install Guide, which outlines the procedure for
installing PICs; and the Port Interface Card Hardware Reference, which
provides detailed information on PICs.
All of these documents can be found on the Documentation and Tools CD-
ROM bundled with each Switch or Switching Router, or at
www.alliedtelesyn.co.nz/support/support.html.
Table: 3 AT-A40/SC, AT-A40/MT, AT-A41/SC and AT-A41/MT LEDs
1
.
LED State Function
Activity/Link/Fault Green A link is open and the port is enabled
Flashing green 100 Mbps activity is occurring
Flashing amber
(and lower LED is Off)
The link has failed at the remote end
Off No link is present
Full Dup/Half
Dup/Col
Green The port is operating at full-duplex
Amber The port is operating at half-duplex
Flashing amber Collisions are occurring
Off No link is present
Both LEDs Alternate flashing of
upper and lower LED,
amber
The switch does not support this model
of uplink module