UPLINK MODULE QUICK INSTALL GUIDE Software Release 2.3.
Uplink Module Quick Install Guide Document Number C613-04022-01 REV E. Copyright © 1999-2001 Allied Telesyn International, Corp. 19800 North Creek Parkway, Suite 200, Bothell, WA 98011, USA. All rights reserved. No part of this publication may be reproduced without prior written permission from Allied Telesyn. Allied Telesyn International, Corp. reserves the right to make changes in specifications and other information contained in this document without prior written notice.
Quick Install Guide 3 Models Covered By This Guide This Quick Install Guide includes information on the following models: ■ AT-A35/SX ■ AT-A35/LX ■ AT-A39/T ■ AT-A40/SC ■ AT-A40/MT ■ AT-A41/SC ■ AT-A41/MT Quick Install Guide updates can be found at www.alliedtelesyn.co.nz/ support/support.html. Compatible Switch Units This section lists all uplink module models, and indicates which switches each model can be installed in.
Uplink Module Installing an Uplink Module Follow these steps to install an uplink module: 1. Before installing an Uplink Module, read the safety information For safety information, see the Safety and Statutory Information booklet for your switch. A copy of this booklet is supplied with each switch, and can also be downloaded from www.alliedtelesyn.co.nz/support/ support.html. AT-82xx Expansion Modules are not compatible with AR800 Series Modular Switching Routers or Rapier Switches.
Quick Install Guide 5 Figure 1: Removing a blank face-plate. A B 6. Prepare the Uplink Module In an antistatic environment, remove the Uplink Module from its packing material. Be sure to observe ESD precautions. Do not attempt to install an Uplink Module or any other expansion option without observing correct antistatic procedures. Failure to do so may damage the switch unit or Uplink Module.
Uplink Module 11. Check that the Power LED on the switch unit’s front panel lights green If the LED fails to light, refer to the Troubleshooting section of the Uplink Module Hardware Reference. 12. Connect the data cables If fitted, remove the Uplink Module’s port dust cover and connect the data cable. Make sure that each cable connection is secure. 13. Check the Uplink Module’s LEDs Table 1 and Table 2 outline the Uplink Module LEDs.
Quick Install Guide 7 Table: 3 AT-A40/SC, AT-A40/MT, AT-A41/SC and AT-A41/MT LEDs1.
