Specifications

Switching delete lacp port 8-97
Software Release 2.7.3
C613-03098-00 REV A
delete lacp port
Syntax DELete LACP POrt={port-list}
where port-list is a port number, range (specified as n-m), or comma-separated
list of port numbers and/or ranges. Port numbers start at 1 and end at m,
where m is the highest numbered switch port, including uplink ports.
Description This command removes ports from LACP’s control and LACP frames are no
longer transmitted across the link. It is good practice to delete LACP from ports
that are linked to non-LACP-capable devices.
The port parameter specifies switch ports to be deleted from LACP's control.
Ports specified must be under the control of LACP. ALL is not a configurable
option; to stop LACP on all ports, use the disable lacp command on
page 8-108.
Examples To delete ports 3 and 5 from LACP, use the command:
del lacp po=3,5
Related Commands add lacp port
disable lacp
enable lacp
set lacp port
show lacp port