Specifications

8-68 Rapier Switch Software Reference
Software Release 2.7.3
C613-03098-00 REV A
2. Add ports to VLANs
Add the ports to these VLANs on the switch by using the following
commands:
add vlan=admin port=6,25-26 frame=tagged
add vlan=training port=6,25-26 frame=tagged
add vlan=training port=7
add vlan=marketing port=6,25-26 frame=tagged
Check the VLAN configuration by using the command:
show vlan
3. Enable STP
All VLANs belong to the default STP, which must be enabled to eliminate
loops in the network. Use the command:
enable stp=default
Configure Switch C
1. Create VLANs
Create the three VLANs using the following commands on the switch:
create vlan=admin vid=2
create vlan=training vid=3
create vlan=marketing vid=4
2. Add ports to VLANs
Add the ports to these VLANs on the switch by using the following
commands:
add vlan=admin port=25-26 frame=tagged
add vlan=training port=25-26 frame=tagged
add vlan=training port=24
add vlan=marketing port=25-26 frame=tagged
add vlan=marketing port=23
Check the VLAN configuration by using the command:
show vlan
3. Enable STP
All VLANs belong to the default STP, which must be enabled to eliminate
loops in the network. Use the command:
enable stp=default
Check that the switch is switching across the ports.
1. Check the traffic on Switch A.
show switch port=1,2,25,26 counter
2. Check the traffic on Switch B.
show switch port=6,7,25,26 counter
3. Check the traffic on Switch C.
show switch port=23-26 counter