Specifications

Switching 8-67
Software Release 2.7.3
C613-03098-00 REV A
To configure the uplink ports in the above example, use the following
commands:
Configure Switch A
1. Create VLANs
Create the three VLANs using the following commands on the switch:
create vlan=admin vid=2
create vlan=training vid=3
create vlan=marketing vid=4
2. Add ports to VLANs
Add the ports to these VLANs on the switch by using the following
commands:
add vlan=admin port=25-26 frame=tagged
add vlan=admin port=1
add vlan=training port=25-26 frame=tagged
add vlan=marketing port=25-26 frame=tagged
add vlan=marketing port=2
Check the VLAN configuration by using the command:
show vlan
3. Enable STP
All VLANs belong to the default STP, which must be enabled to eliminate
loops in the network. Use the command:
enable stp=default
Configure Switch B
1. Create VLANs
Create the three VLANs using the following commands on the switch:
create vlan=admin vid=2
create vlan=training vid=3
create vlan=marketing vid=4
Table 8-18: Parameters for meshed VLAN network with tagged ports
Switch A Switch B Switch C
VLAN name VID Tagged
ports
Untagged
ports
Tagged
ports
Tagged
ports
Tagged
ports
Tagged
ports
Admin VID=2 25,26 1 6,25,26 - 25,26 -
Training VID=3 25,26 - 6,26,25 7 26,25 24
Marketing VID=4 25,26 2 6,25,26 - 25,26 23
STP Default STP Default STP Default STP
Enabled Enabled Enabled