Specifications

8-234 show vlanrelay Rapier Switch Software Reference
Software Release 2.7.3
C613-03098-00 REV A
show vlanrelay
Syntax SHow VLANRelay[=name]
where name is a unique name for the VLAN relay entity 1 to 15 characters long.
Valid characters are uppercase and lowercase letters, digits, the underscore,
and the hyphen.
Description This command displays information about one or all of the currently-
configured VLAN relay entities (Figure 1, Table 1).
The vlanrelay parameter specifies the name of the VLAN relay entity for which
to show information. If the name is not given, information about all VLAN
relay entities is displayed.
Figure 8-51: Example output from the show vlanrelay command
Example To show the configuration and counters for the VLAN relay entity SNARelay,
use the command:
show vlanrelay=snarelay
VLAN relay entities
------------------------------------------------------------
Name ............................... SNARelay
Enabled ........................... Yes
Debugging ......................... No
Protocol .......................... 00
Protocol .......................... 04
VLAN .............................. 2 (Accounts)
VLAN .............................. 5 (Admin)
VLAN .............................. 16 (Sales)
Packet counters:
VLAN 2 to VLAN 5 ................. 2345
VLAN 16 ................ 148
VLAN 5 to VLAN 2 ................. 2567
VLAN 16 ................ 754
VLAN 16 to VLAN 2 ................ 174
VLAN 5 ................ 802
------------------------------------------------------------
Table 8-68: Parameters in the output of the show vlanrelay command
Parameter Meaning
Name Name of the VLAN relay entity.
Enabled Whether the VLAN relay entity is enabled.
Debugging Whether packet debugging for the VLAN relay entity is
enabled.
Protocol Protocol number of each protocol that is relayed by the
VLAN relay entity.
VLAN Numerical VLAN Identifier and name of each VLAN added
to the VLAN relay entity.
Packet counters Number of packets relayed between VLANs by this VLAN
relay entity.