Specifications

Switching show vlan 8-231
Software Release 2.7.3
C613-03098-00 REV A
show vlan
Syntax SHow VLAN[={vlan-name|1..4094|ALL}]
where vlan-name is a unique name from 1 to 32 characters. Valid characters are
uppercase and lowercase letters, digits, the underscore, and the hyphen. The
vlan-name cannot be a number or ALL.
Description This command displays information about the specified VLAN. If no VLAN or
ALL is specified, then all VLANs are displayed (Figure 8-49 on page 8-231,
Table 8-66 on page 8-232).
Figure 8-49: Example output from the show vlan command
VLAN Information
---------------------------------------------------------------------------
Name ............... default
Identifier ......... 1
Status ............. static
Private VLAN ....... No
Protected .......... No
Untagged ports ..... 1,3-23
Tagged ports ....... None
Spanning Tree ...... default
Trunk ports ........ None
Mirror port ........ None
Attachments:
Module Protocol Format Discrim MAC address
-------------------------------------------------------------------
GARP Spanning tree 802.2 42 -
IP IP Ethernet 0800 -
IP ARP Ethernet 0806 -
-------------------------------------------------------------------
Name ............... v2
Identifier ......... 2
Status ............. dynamic
Private VLAN ....... Yes
Protected .......... No
Untagged ports ..... 2,24
Tagged ports ....... None
Spanning Tree ...... default
Trunk ports ........ None
Mirror port ........ None
Attachments:
Module Protocol Format Discrim MAC address
-------------------------------------------------------------------
GARP Spanning tree 802.2 42 -
-------------------------------------------------------------------
Private Uplink:
Uplink ports ...... 21-24
Private Groups:
Group ports ...... 3-5
Group ports ...... 6-9
--------------------------------------------------------------------