Specifications

Switching show switch qos 8-229
Software Release 2.7.3
C613-03098-00 REV A
show switch qos
Syntax SHow SWItch QOS
Description This command displays the current mapping of user priority level to QOS
egress queue for the switch (Figure 8-47 on page 8-229, Table 8-64 on
page 8-229).
Packets that originate on the switch or are routed by the switch’s software have
been assigned a Quality of Service priority of 7. To ensure that these packets are
transmitted promptly, you should not assign priority 7 to a low-numbered
egress queue.
Figure 8-47: Example output from the show switch qos command
Example To display the current configuration of the priority level to QOS egress queue
mappings, use the command:
show switch qos
Related Commands set switch qos
set qos hwpriority in Chapter 35, Quality of Service (QoS) on Switch Ports
show qos hwpriority in Chapter 35, Quality of Service (QoS) on Switch Ports
Priority Level QOS egress queue
-------------------------------------
0 ................... 1
1 ................... 0
2 ................... 0
3 ................... 1
4 ................... 2
5 ................... 2
6 ................... 3
7 ................... 3
Table 8-64: Parameters in the output of the show switch qos command
Parameter Meaning
Priority level Priority level of the received frame.
QOS egress queue Quality Of Service egress queue that frames with this
priority level join.