Specifications

Switching show switch port 8-223
Software Release 2.7.3
C613-03098-00 REV A
Configured speed/duplex Speed mode configured for this port. Either
“Autonegotiate” or a combination of a speed (one of “10
Mbps”, “100 Mbps” or “1000 Mbps”) and a duplex mode
(one of “half duplex” or “full duplex”), and optionally “(by
autonegotiation)”.
Actual speed/duplex The port speed and duplex mode that this port is actually
running at. A combination of a speed (either “10 Mbps”,
“100 Mbps” or “1000 Mbps”) and a duplex mode (either
“half duplex” or “full duplex”).
Configured master/slave mode The master/slave mode configured for this port; either
“Autonegotiate’, “Master”, “Slave”, or “Not applicable”.
Actual master/slave mode The master/slave mode actually selected; either “-”,
“Master”, “Slave”, or “Not applicable”.
Acceptable Frame Types The value of the Acceptable Frame Types parameter, either:
“Admit All Frames” or “Admit Only VLAN-tagged Frames”.
Broadcast rate limit The limit of the rate of reception of broadcast frames for
this port, in frames per second.
Multicast cast rate limit The limit of the rate of reception of multicast frames for this
port, in frames per second.
DLF rate limit The limit of the rate of reception of DLF (destination lookup
failure) frames for this port, in frames per second.
Learn limit The number of MAC addresses that may be learned for this
port. Once the limit is reached, the port is locked against
any new MAC addresses. Either “None” or a number from
1 to 256.
Intrusion action Whether the port should discard, trap, or disable when a
frame is received from an unknown MAC address and the
port is locked.
Current learned, lock state The number of MAC addresses currently learned on this
port and the state of locking for this port. The current
learned parameter is incremented when a Learn Limit is set
for the port. The lock state is either “not locked”, “locked
by limit”, or “locked by command”.
Mirroring The traffic mirroring for traffic in and out of this port. Either
“None”, “Rx” (for traffic received by this port), “Tx” (for
traffic sent on this port), or “Both”. The port where
mirrored frames are sent is also displayed.
Is this port mirror port Whether this port is a mirror port. Either “No” or “Yes”.
Enabled flow control Flow control parameters set for the port; “Pause” or “-”. If
flow control is implemented on the switch, then Pause flow
control is applied to the port.
Send tagged pkts for VLAN(s) Name and VLAN Identifier (VID) of the tagged VLAN(s), if
any, to which the port belongs.
Port-based VLAN Name and VLAN Identifier (VID) of the port-based VLAN to
which the port belongs.
Ingress Filtering Whether ingress filtering is on.
Trunk Group Name of trunk group to which the port belongs, if any.
STP Name of the STP to which the port belongs.
Table 8-62: Parameters in the output of the show switch port command
Parameter Meaning