Specifications

Switching show switch l3filter 8-221
Software Release 2.7.3
C613-03098-00 REV A
Example To display all filters, use the command:
sh swi l3f
To display entry 3 from filter 1, use the command:
sh swi l3f=1 ent=3
Related Commands add switch l3filter match
add switch l3filter entry
delete switch l3filter
delete switch l3filter entry
disable switch l3filter
enable switch l3filter
set switch l3filter match
set switch l3filter entry
No Match Action Action to take when a packet matches the specified ingress/
egress ports for this entry; one or more of “sp”
(SETPRIORITY), “sc” (FORWARD or SENDCOS), “st”
(SETTOS), “dn” (DENY), “se” (SENDEPORT), “sm”
(SENDMIRROR), “mpt” (MOVEPRIOTOTOS), “mtp”
(MOVETOSTOPRIO), “sds” (SETIPDSCP), “sn”
(SENDNONUNICASTTOPORT).
Ent. Filter entry number.
S-Address, S-Mask, S-Port Source IP address, source mask and source port to match.
D-Address, D-Mask, D-Port Destination IP address, destination mask and destination
port to match.
Prot Protocol to match.
Iport Ingress port number to match.
Action Action to take when a packet matches this entry; either
“sp” (SETPRIORITY), “sc” (FORWARD or SENDCOS), “st”
(SETTOS), “dn” (DENY), “se” (SENDEPORT), or “sm”
(SENDMIRROR).
TTL TTL value to match.
Eport Egress port number to match.
TOS TOS value to match.
NewTOS New TOS value to assign to packets matching the entry.
Type Value of the protocol-type to match. If a 5 byte hexadecimal
number is shown then the packet type is SNAP, if 2 bytes are
shown then the packet type is either Ethernet type II or
802.3 and (E-II) or (SNAP) is appended respectively.
Port New output port to use for packets matching the entry.
Priority New priority value to assign to packets matching the entry.
Table 8-61: Parameters in the output of the show switch l3filter command (Continued)
Parameter Meaning