Specifications

8-218 show switch hwfilter Rapier Switch Software Reference
Software Release 2.7.3
C613-03098-00 REV A
show switch hwfilter
Syntax SHow SWItch HWFilter [CLASSifier=classifier-list]
where classifier-list is either an integer from 1 to 9999; a range of integers
(specified as 1-4), or a comma-separated list of classifier numbers and/or
ranges (1, 3, 4-9).
Description This command displays hardware-based filtering entries created when using
the add switch hwfilter classifier command on page 8-77 (Figure 8-41 on
page 8-218, Figure 8-42 on page 8-218, Table 8-60 on page 8-219). All of the
specified classifiers must exist and must already be incorporated into a filter
entry. If classifier is not specified, summary information is displayed for filters
currently defined.
Figure 8-41: Example output from the show switch hwfilter command
Figure 8-42: Example output from the show switch hwfilter classifier command
Switch Hardware Filter Summary Information
------------------------------------------------------------
Status ............... ENABLED
Number of Filters .... 12
Filter ............... 1
Classifier ........... 3
Filter ............... 2
Classifier ........... 100
Filter ............... 3
Classifier ........... 101
------------------------------------------------------------
-----------------------------------------------------------
Filter ............... 1
Classifier ........... 3
Action ............... sp
New IP DSCP .......... -
New TOS .............. -
Port ................. -
Priority ............. 5
No Match Action ...... st, sp
No Match DSCP ........ -
No Match TOS ......... 2
No Match Port ........ -
No Match Priority .... 1
-----------------------------------------------------------