Specifications

Switching show switch debug 8-213
Software Release 2.7.3
C613-03098-00 REV A
show switch debug
Syntax SHow SWItch DEBug
Description This command displays debugging information for the switch (Figure 8-38 on
page 8-213, Table 8-57 on page 8-213).
Figure 8-38: Example output from the show switch debug command
Example To display debugging information for the switch, use the command:
show switch debug
Related Commands disable switch debug
enable switch debug
Enabled Switch Debug Modes Output Timeout
----------------------------------------------------------
ARL, DMA 16 12345
----------------------------------------------------------
Table 8-57: Parameters in the output of the show switch debug command
Parameter Meaning
Enabled Switch Debug Modes Whether the debugging option for the switch is ARL, CMIC”,
DMA, QOS, S5600, PHY, or None.
Output Output device for the switch. This is shown when a debug
mode is enabled.
Timeout Time in seconds that debugging options for the switch are
enabled. This is shown when a debug mode is enabled.