Specifications

8-202 show stp Rapier Switch Software Reference
Software Release 2.7.3
C613-03098-00 REV A
Figure 8-32: Example output from the show stp summary command
Example To show the current settings of the company STP, use the command:
show stp=company
Related Commands create stp
destroy stp
disable stp
enable stp
show stp counter
show stp port
set stp
Switch Hello Time The value of the Hello Time parameter when this switch is
the Root or is attempting to become the Root. This
parameter is set by the hellotime parameter in the set stp
command.
Switch Forward Delay The value of the Forward Delay parameter when this switch
is the Root or is attempting to become the Root. This
parameter is set by the forwarddelay parameter in the set
stp command.
Hold Time The minimum time in seconds between the transmission of
configuration BPDUs through a given LAN Port. The value
of this fixed parameter is 1, as specified in IEEE
Standard 802.1d. This parameter applies only to STP
running in standard mode.
Transmission Limit In rapid mode, this indicates the number of BPDUs that may
be transmitted in the interval specified by Hello Time. The
value of this fixed parameter is 3, as specified in IEEE
Standard 802.1t.
STP Name Mode Ports Enabled Ports Disabled Bridge Role
------------------------------------------------------------
Rstp1 Rapid 0 2 Root Bridge
Default Standard 0 21 Root Bridge
------------------------------------------------------------
Table 8-51: Parameters in the output of the show stp summary command
Parameter Meaning
STP name Name of the Spanning Tree Protocol entry.
Mode Whether STP is running in standard or rapid mode.
Ports Enabled Number of ports being considered by the Spanning Tree
Algorithm.
Ports Disabled Number of ports that have been disabled and are not active
in the Spanning Tree Algorithm.
Bridge Role Role of the bridge in the STP, either None, Designated, or
Root.
Table 8-50: Parameters in the output of the show stp command (Continued)
Parameter Meaning