Specifications

8-200 show stp Rapier Switch Software Reference
Software Release 2.7.3
C613-03098-00 REV A
show stp
Syntax SHow STP[={stp-name|ALL}] [SUMmary]
Description This command displays information about the specified Spanning Tree
Protocol instance (STP), or all STPs (Figure 8-31, Table 8-50 on page 8-201).
If the summary parameter is specified, then a summary table of all configured
STPs is displayed (Figure 8-32 on page 8-202, Figure 8-51 on page 8-202).
Figure 8-31: Example output from the show stp command
STP Information
------------------------------------------------------------
Name .................. grey
Mode .................. Rapid
RSTP Type ............. Normal
VLAN members .......... vlan4 (4)
Status ................ ON
Number of Ports ....... 2
Number Enabled ...... 2
Number Disabled ..... 0
Bridge Identifier ..... 32768 : 00-00-cd-05-19-28
Bridge Priority ....... 32768
Root Bridge ........... 32768 : 00-00-cd-05-19-28
Designated Bridge ..... 32768 : 00-00-cd-05-19-28
Root Port ............. (n/a)
Root Path Cost ........ 0
Max Age ............... 20
Hello Time ............ 2
Forward Delay ......... 15
Switch Max Age ........ 20
Switch Hello Time ..... 2
Switch Forward Delay .. 15
Transmission Limit .... 3
Name .................. default
Mode .................. Standard
RSTP Type ............. (n/a)
VLAN members .......... default (1)
vlan8 (8)
vlan9 (9)
vlan10 (10)
vlan11 (11)
vlan12 (12)
vlan13 (13)
vlan14 (14)
Status ................ OFF
Number of Ports ....... 22
Number Enabled ...... 0
Number Disabled ..... 22
Bridge Identifier ..... 32768 : 00-00-cd-05-19-28
Bridge Priority ....... 32768
Designated Root ....... 32768 : 00-00-cd-05-19-28
Root Port ............. (n/a)
Root Path Cost ........ 0
Max Age ............... 20
Hello Time ............ 2
Forward Delay ......... 15
Switch Max Age ........ 20
Switch Hello Time ..... 2
Switch Forward Delay .. 15
Hold Time ............. 1