Specifications

Switching show lacp port counter 8-185
Software Release 2.7.3
C613-03098-00 REV A
Related Commands add lacp port
delete lacp port
set lacp port
show lacp
show lacp port counter
Syntax SHow LACP POrt[={port-list|ALL}] COUnter
where port-list is a port number, range (specified as n-m), or a comma-separated
list of port numbers and/or ranges. Port numbers start at 1 and end at m,
where m is the highest numbered Ethernet switch port, including uplink ports.
Description This command displays LACP counters for the specified switch ports, or all
switch ports.
Figure 8-18: Example output from the show lacp port counter command
Examples To show the LACP port counters for all ports, use the command:
sh lacp po cou
Related Commands reset lacp port counter
show lacp
show lacp port
LACP Port Counters
--------------------------------- ------------------------------------------------
-
Port 1
Received: Transmitted
LACP Pkts........................ 0 LACP Pkts .......................... 0
Invalid LACP Pkts................ 0
----------------------------------------------------------------------------------
Table 8-39: Parameters in output of the show lacp port counter command
Parameter Meaning
Received Counters for LACP frames received
LACP Pkts The number of valid LACPDU frames received
Invalid LACP Pkts The number of invalid LACP packets received. This includes those
with an invalid type/length field, subtype field, actor information
length field, partner information length field, collector information
length field, terminator information length field, or invalid frame
length.
Trans mi tt ed Counters for LACP packet transmitted.
LACP Pkts The number of LACPDU frames transmitted.