Specifications

Switching show lacp port 8-183
Software Release 2.7.3
C613-03098-00 REV A
show lacp port
Syntax SHow LACP POrt[={port-list|ALL}]
where port-list is a port number, range (specified as n-m), or a comma-separated
list of port numbers and/or ranges. Port numbers start at 1 and end at m,
where m is the highest numbered Ethernet switch port, including uplink ports.
Description This command displays LACP information about a specific switch port or all of
them (Figure 8-17).
Figure 8-17: Example output from the show lacp port command
LACP Port Information
----------------------------------------------------------------------------------
Actor Port ........................ 1
Trunk Group ................ lacp1 Partner Information
Selected ................. Selected Partner System Priority ........ 8000
Port Priority .................8000 Partner System 00-3e-0a-12-00-01
LACP Port Number ............. 0001 Port Key ...........................4
Port Key ... .....................6 Port Priority ................... 500
Admin Key .................... 12 Port Number .................... 0002
Mode ....................... Active Mode ......................... Active
Periodic...................... Fast Periodic........................ Fast
Individual ..................... No Individual ....................... No
Synchronised ...................Yes Synchronised .....................Yes
Collecting .....................Yes Collecting .......................Yes
Distributing .................. Yes Distributing .................... Yes
Defaulted ...................... No Defaulted ........................ No
Expired ........................ No Expired .......................... No
Actor Churn................ .....No
Partner Churn................ ...No
----------------------------------------------------------------------------------
Table 8-38: Parameters in output of the show lacp port command
Parameter Meaning
Port Number of the port.
Trunk Group Name of trunk group to which the port belongs. It is a name that
LACP has automatically assigned to an aggregated link.You cannot
manually create a trunk starting with the letters LACP. If LACP
created, then the name has the prefix LACP followed by a numeric,
such as LACP72. This number is the same as the new interface index
shown by the show interface command.
Priority User-configurable priority assigned to the port.
LACP Port Number LACP encoded port number.
Port Key Key that LACP has assigned to the port.
Admin Key User-configurable key assigned to the port.
Mode The participation mode. If active, the port sends LACPDU packets
regardless of the partner port's participation. If passive, the port
sends LACPDU packets after receiving one from its partner port.
Periodic User-configurable time period between transmission of periodic
LACPDU packets; one of "Fast" (1 second) or "Slow" (30 seconds).