Specifications

8-178 set switch port Rapier Switch Software Reference
Software Release 2.7.3
C613-03098-00 REV A
If you override a port’s autonegotiation on Rapier i Series switches by setting
it to a fixed speed/duplex setting, automatic MDI/MDI-X detection is also
overridden. The port defaults to MDI-X.
Examples To set the speed of port 5 to 10Mbps, half duplex, use the command:
set switch port=5 speed=10mhalf
To limit the rate of destination lookup failure packets to 1000 packets per
second for the processing block of ports 17-24, use the command:
set switch port=17-24 dlflimit=1000
To accept only VLAN-tagged frames on port 2, use the command:
set switch port=2 acceptable=vlan
To set the maximum bandwidth for port 1to 512Kbps, use the command:
set switch port=1 maxbandwidth=512
Related Commands disable switch port
enable switch port
show switch port
1000MHAUTO 1000 Mbps, half duplex, autonegotiate
1000MFAUTO 1000 Mbps, full duplex, autonegotiate
Table 8-34: switch port speed values (Continued)
Value Meaning