Specifications

Switching purge lacp 8-141
Software Release 2.7.3
C613-03098-00 REV A
enable vlanrelay debug
Syntax ENAble VLANRelay=name DEBug
where name is a unique name for the VLAN relay entity 1 to 15 characters long.
Valid characters are uppercase and lowercase letters, digits, the underscore,
and the hyphen.
Description This command enables the output of debugging information about packets
relayed by the VLAN relay entity. The relay entity must already exist, and
VLAN relay debugging must be currently disabled. Debugging of VLAN relay
entities is disabled by default.
The format of the output messages from packet debugging is as follows:
vr: 2->3: 0000cd001234 0000cd004321 040403060708090560403
The first part of the output shows which VLANs the packet is being relayed
between. The second part shows the packet, with destination and source MAC
addresses separated from the payload of the packet.
Example To enable the display of packets relayed by the VLAN relay entity SNARelay,
use the command:
enable vlanrelay=snarelay debug
Related Commands add vlanrelay
delete vlanrelay
disable vlanrelay debug
enable vlanrelay
purge lacp
Syntax PURge LACP
Description This command destroys all LACP configuration and restores the defaults to all
the configurable parameters. The LACP parameters for all ports are reset to
their defaults. This command returns the LACP module to the status that
existed when first powered on.
Example To purge the LACP configuration, use the command:
pur lacp
Related Commands enable lacp
disable lacp
set lacp port