Specifications

8-138 enable switch port Rapier Switch Software Reference
Software Release 2.7.3
C613-03098-00 REV A
enable switch port
Syntax ENAble SWItch POrt={port-list|ALL} [FLOw=PAUSE]
port-list is a port number, range (specified as n-m), or comma-separated list of
numbers and/or ranges. Port numbers start at 1 and end at m, where m is the
highest numbered switch Ethernet port, including uplink ports.
Description This command enables a port or group of ports on the switch, or enables the
flow control mechanism. When the port is enabled, it sends and receives
packets subject to the operation of STP. Enabling the switch port does not affect
STP on the port. Switch ports are enabled by default.
To enable a port that has been disabled by the Port Security function, use the
set switch port command on page 8-174 rather than this command.
The port parameter specifies the port to be enabled, or which are to have flow
control methods enabled.
The flow parameter specifies the type of flow control to be enabled for the port.
If pause is specified, flow control for full duplex ports by sending PAUSE
frames is enabled. pause flow control is enabled by default.
Example To enable ports 2, 4 and 6, use the command:
ena swi po=2,4,6
Related Commands disable switch port
reset switch port
show switch port