Specifications

8-122 enable lacp debug Rapier Switch Software Reference
Software Release 2.7.3
C613-03098-00 REV A
enable lacp debug
Syntax ENAble LACP DEBug={MSG|PACKet|STAte|TRAce|DEV|PERsistent|
ALL}}
Description This command enables the LACP debugging facility, which is disabled by
default. The msg option displays the decoded form of incoming and outgoing
LACP packets.The packet option displays all incoming and outgoing LACP
packets. The state option displays internal state machine changes. The trace
option displays the function call tree. The dev option displays internal support
information. The persistent option enables the debug state to persist over one
reboot. If all is specified, the debugging process is enabled for all options. The
default is all.
Related Commands disable lacp debug
show lacp
enable mstp
Syntax ENAble MSTp
Description This command enables the operation of the multiple spanning tree algorithm
on the switch. Multiple spanning tree protocol (MSTP) enables a number of
VLANs to each use separate active topologies throughout a virtual bridged
LAN. By default MSTP is disabled on switch start-up. MSTP must be enabled
before the following commands can be used:
enable mstp cist port
disable mstp cist port
enable mstp msti port
disable mstp msti port
Once MSTP has been enabled, any port for the CIST and the existing MSTIs can
be enabled or disabled. Enabling MSTP will initialise the status for the switch
and all of its ports. MSTP cannot be enabled while there are also STP instances
enabled. All STP instances must be disabled before MSTP can be enabled.
Examples To enable MSTP, use the commands:
ena mst
Related Commands disable mstp
show mstp