Specifications

Switching disable switch l3filter 8-117
Software Release 2.7.3
C613-03098-00 REV A
disable switch hwfilter
Syntax DISable SWItch HWFilter
Description This command disables classifier-based packet filtering.
Hardware filtering is automatically disabled when the last filter match is
removed, however this command may be used to manually disable filtering if
this is required.
Some other modules and processes (such as IGMP snooping) require filtering
to be enabled at all times. If any of these are active when the disable switch
hwfilter command is entered, it has no effect and an error message results.
Example To disable existing classifier-based packet filters, use the command:
dis swi hwf
Related Commands enable switch hwfilter
disable switch hwfilter
disable switch l3filter
Syntax DISable SWItch L3Filter
Description This command disables hardware-based Layer 3 packet filtering.
On the Rapier i Series switches only, hardware filtering is automatically
disabled when the last filter match is removed; however, this command may be
used to manually disable filtering. Some other modules and processes (such as
IGMP snooping) require filtering to be enabled at all times. If any of these are
active when this command is entered, it has no effect and an error message
results.
Example To disable existing hardware-based Layer 3 packet filters, use the command:
dis swi l3f
Related Commands enable switch l3filter
show switch l3filter