Specifications

8-116 disable switch ageingtimer Rapier Switch Software Reference
Software Release 2.7.3
C613-03098-00 REV A
disable switch ageingtimer
Syntax DISable SWItch AGEingtimer
Description This command stops the ageing timer from ageing dynamically learned entries
in the forwarding database. The default setting for the ageing timer is enabled.
Example To disable the ageing of learned MAC addresses, use the command:
dis swi age
Related Commands enable switch ageingtimer
set switch ageingtimer
show switch
disable switch debug
Syntax DISable SWItch DEBug={ARL|CMIC|DMA|QOS|S5600|PHY|ALL}
Description This command disables the specified switch debug mode or all switch
debugging. The debug parameter specifies the switch debug mode to be
disabled (Table 8-22 on page 8-116).
Example To disable all switch debugging, use the command:
dis swi deb=all
Related Commands enable switch debug
show switch
Table 8-22: Switch debugging options
Debug Options Description
ARL Operations related to the forwarding database.
CMIC Operations at the CMIC layer
DMA Operations related to Direct Memory Access requests.
QOS Operations related to Quality of Service
S5600 Operations related to the switching hardware.
PHY Operations related to the PHY port interfaces.
ALL All debug options